CCNA R&S Lab 2014

[Admin]

Lab 1. Configuring Static Routing via Interfaces



CCNA_Lab_1
Task 1: Configure the hostnames on routers R1, R2, and Sw1 as illustrated in the topology.
Task 2: Configure static routes via the FastEthernet0/0 interface on R2 to all the subnets configured on the Loopback addresses configured on R1. Verify your static route configuration with appropriate commands. Ping each Loopback interface configured on R1 from R2 to validate your static route configuration.
Hướng dẫn:
R1(config)# int f0/0
R1(config-if)# ip address 172.27.32.1 255.255.224.0
R1(config-if)# no shutdown
R1(config)# interface loopback 100
R1(config-if)# ip address 172.100.1.1 255.255.255.255
R1(config)# interface loopback 101
R1(config-if)# ip address 172.101.0.1 255.255.255.248
R1(config-if)#exit
R1(config)# interface loopback 102
R1(config-if)# ip address 172.102.5.1 255.255.128.0
R2(config)# int f0/0
R2(config-if)# ip add 172.27.32.2 255.255.224.0
R2(config-if)# no shutdown
R2(config)# ip route 172.100.1.1 255.255.255.255 fastethernet0/0
R2(config)# ip route 172.101.0.0 255.255.255.248 fastethernet0/0
R2(config)# ip route 172.102.0.0 255.255.128.0 fastethernet0/0[/hide]